TK-2402(V)/2402/2406/2407
3
SYSTEM SET-UP
REALIGNMENT
Choose the type of transceiver
Transceiver programming
Delivery
Merchandise received
Are you using the speaker microphone?
A personal computer, programming interface (KPG-22A/22U),
and FPU (programming software) are required for programming.
(The frequency, TX power HI/LOW, and signaling data are
programmed for the transceiver.)
YES
NO
KMC-21, KMC-45
Speaker microphone
(Option)
Are you using the optional antenna?
YES
NO
KRA-22 or KRA-26
Optional antenna
TX/RX 136~174
5.0W
TK-2402(V) K
TK-2402 K, P
TK-2406 M
TK-2407 M
Frequency range (MHz)
RF power
Type
1. Modes
User mode
Data programming mode
PC test mode
PC tuning mode
PC mode
Wireless clone mode
Mode
Function
User mode
For normal use.
PC mode
Used for communication between the trans-
ceiver and PC.
Data programming
mode
Used to read and write frequency data and
other features to and from the transceiver.
PC test mode
Used to check the transceiver using the PC.
This feature is included in the FPU.
Wireless clone
mode
Used to transfer programming data from one
transceiver to another.
2. How to Enter Each Mode
Mode
Operation
User mode
Power ON
PC mode
Received commands from PC
Wireless clone mode
[PTT] + [Side] + Power ON (Two seconds)
3. PC Mode
3-1. Preface
The transceiver is programmed by using a personal com-
puter, a programming interface (KPG-22A/22U) and FPU
programming software.
The programming software can be used with a PC. Fig-
ure 1 shows the setup of a PC for programming.
3-2. Connection Procedure
1. Connect the transceiver to the personal computer with
the interface cable.
Note:
• You must install the KPG-22U driver in the computer to
use the USB programming interface cable (KPG-22U).
Содержание TK-2402
Страница 42: ...TK 2402 V 2402 2406 2407 ...