Kenwood NX-203, Руководство по обслуживанию

Страница: 36 / 109

NX-203
36
TROUBLE SHOOTING
●
Checking the output signal
from the ASIC
Points to be checked Normal voltage
SBC R432 3.3V
When an abnormal
value is confirmed.
When a normal
value is confirmed.
When a normal
value is confirmed.
●
The LCD displays control
It is unlikely that the BGA parts are broken.
Points to be checked Normal voltage
/CS4 IC402 (7 pin) 3.3V → 0V → 3.3V
Points to be checked Normal voltage
/DRST C109 3.3V
Points to be checked Normal voltage
5A IC708 (5 pin) 5.0V
If 5A is 0V, parts other than the BGA are broken.
If the /CS4 is 0V or 3.3V, the ASIC/FLASH/SRAM
may be broken.
If the /DRST is 0V, the ASIC/FLASH/SRAM are broken.
Remove R432. If the ASIC side is 0V,
the ASIC/FLASH/SRAM may be broken.
Points to be checked Normal voltage
/LCDRST R406 3.3V
Remove R406. If the ASIC side is 0V,
the ASIC/FLASH/SRAM may be broken.
When a normal
value is confirmed.
When a normal
value is confirmed.
When a normal
value is confirmed.
When a normal
value is confirmed.
When an abnormal
value is confirmed.
When an abnormal
value is confirmed.
When an abnormal
value is confirmed.
When an abnormal
value is confirmed.
●
When an error display appears on the LCD.
The LCD displays “INIT ERROR1”.
An error occurs when the ASIC internal RAM reads
or writes. The ASIC may be broken.
The LCD displays “INIT ERROR2”.
An error occurs when the DSP internal RAM reads
or writes. The DSP may be broken.
The LCD displays “INIT ERROR3”.
An error occurs when the SRAM internal RAM
reads or writes. The SRAM may be broken.
■
Descriptions of signal names
1) RST(RESET) : ASIC reset signal LOW

Reset
2) /BINT : Battery fi nal voltage monitoring LOW

Final voltage
3) /PSW : Power switch signal LOW

ON
4) /FRST : FLASH reset signal LOW

Reset
5) SBC : Switch B control HIGH

ON
6) /DRST : DSP reset signal LOW

Reset
7) /LCDRST : LCD reset signal LOW

Reset
8) /CS4 : LCD controller chip select signal LOW

Active
9) 5A : Analog peripheral control 5.0V power supply