Kenwood KMM-BT505DAB, Инструкция по эксплуатации

Страница: 35 / 124

ENGLISH
29
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Symptom Remedy
General
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
“MISWIRING CHECK WIRING
THEN PWR ON” appears. Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
“PROTECTING SEND SERVICE”
appears. Send the unit to the nearest service center.
Source cannot be selected. Check the [SOURCE SELECT] setting. (Page
4
)
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
Clean the connectors. (Page 27)
The unit does not work at all. Reset the unit. (Page 3)
Correct characters are not
displayed. • This unit can only display uppercase letters, numbers,
and a limited number of symbols.
• Depending on the display language you have selected
(page 5), some characters may not be displayed
correctly.
Digital Radio
DAB reception is poor. Make sure [ON] is selected for [DAB ANT POWER] .
(Page 4)
“DAB ANT ERR” Check the DAB antenna. If a passive antenna (without
a booster) is used, set [DAB ANT POWER] to [OFF] .
(Page 4)
“RELATED SERV FOUND” • Press the volume knob to activate Soft-Link. (Page 7)
• Press
to cancel.
TROUBLESHOOTING
Symptom Remedy
Analog
Radio
• Radio reception is poor.
• Static noise while listening
to the radio.
Connect the antenna firmly.
USB/iPod
Playback order is not as
intended. The playback order is determined by the order in which
file name were recorded (USB).
Elapsed playing time is not
correct. This depends on the recording process earlier (USB).
“READING” keeps flashing. • Do not use too many hierarchical levels and folders.
• Reattach the device (USB/iPod/iPhone).
“UNSUPPORTED DEVICE”
appears. • Check whether the connected USB device is compatible
with this unit and ensure the file systems are in
supported formats. (Page 27)
• Reattach the USB device.
“UNRESPONSIVE DEVICE”
appears. Make sure the USB device is not malfunction and
reattach the USB device.
“USB HUB IS NOT
SUPPORTED” appears. This unit cannot support a USB device connected via a
USB hub.
• The source does not
change to “USB” when
you connect a USB device
while listening to another
source.
• “USB ERROR” appears.
The USB port is drawing more power than the design
limit. Turn the power off and unplug the USB device.
Then, turn on the power and reattach the USB device.
If this does not solve the problem, turn the power off
and on (or reset the unit) before replacing with another
USB device.
The iPod/iPhone does not
turn on or does not work. • Check the connection between this unit and iPod/
iPhone.
• Disconnect and reset the iPod/iPhone using hard reset.
“LOADING” appears when
you enter search mode by
pressing
.
This unit is still preparing the iPod/iPhone music list. It
may take some time to load, try again later.
JS_KWD_KMM_BT505DAB_EN_5th Draft.indd 29 JS_KWD_KMM_BT505DAB_EN_5th Draft.indd 29 9/27/2018 9:25:34 AM 9/27/2018 9:25:34 AM