Connection/Installation
28
Ñ
Microphone unit
1) Check the installation position of the
microphone (accessory
4
).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory
4
), and stick the microphone to
the place shown below.
4) Wire the microphone cable up to the unit
with it secured at several positions using tape
or other desired method.
5) Adjust the direction of the microphone
(accessory
4
) to the driver.
4
Fix a cable with a commercial item of tape.
Ñ
Removing the trim plate
1) Engage the catch pins on the extraction key
(accessory
5
) and remove the two locks on
the lower level.
Lower the trim plate (accessory
8
) and pull it
forward as shown in the figure.
5
8
Lock
Catch
NOTE
• The trim plate can be removed from the top side
in the same manner.
2) When the lower level is removed, remove the
upper two locations.
Ñ
Removing the unit
1) Remove the trim plate.
2) Insert the two extraction key (accessory
5
)
deeply into the slots on each side, as shown.
5
3) Lower the extraction key toward the bottom,
and pull out the unit halfway while pressing
towards the inside.
NOTE
• Be careful to avoid injury from the catch pins on
the extraction key.
4) Pull the unit all the way out with your hands,
being careful not to drop it.
