34
DDX6027/6027Y/7017
DDX7037/7047/7067
●
MECHA ADJ Screen
• Panel mecha position adjustment is to be conducted.
MECHA ADJ screen
C H :
∗∗ ∗ ∗ ∗ ∗ ∗
V A L
∗ ∗
TEST MODE
MECHA Adjust
Return
MECHA Adjust
Mecha Adjusting
Return
MECHA Adjust
Mecha Adjust OK/NG
Return
Key Specification
MECHA Adjust: Mecha position adjustment will begin.
Return: Test Mode Main Screen is displayed.
MECHA Adjust in progress
MECHA Adjust complete
Note: In case of NG, enter the Test Mode again and re-do
from the beginning.
●
Chroma Screen
• Chroma data adjustment will be conducted.
• Adjustment is conducted with a remote controller (Audio
SW).
Note: Chroma data on the EEPROM can be cleared with
the Clear key in the Service screen.
Key Specification (Remote Controller)
Direct : Chroma IC Adjustment Mode ON/OFF (EEPROM
writing)
Play/Pause: Chroma setting value Confirm/Rehearse
Tenkey 7: Chroma adjustment To the next item.
Tenkey 8: Chroma setting value change (UP)
Tenkey 9: Chroma adjustment To the next item.
Tenkey 0: Chroma setting value change (DW)
●
Source / Set Up / Audio Screen
• The same as the normal screen (Other than Test Mode).
However, when SetUp key and Audio key are pressed, re-
turns to Test Mode Main screen.
●
Security Code Writing Screen
• Security code is managed in pair with serial number. Secu-
rity Code is written in this screen. (Other than K/R destina-
tions)
• From Set Up screen, press Security Set Up key.
• In case of other than K/R destinations, only when EEPROM
Security Code is blank, Set key is displayed. Press the key.
• The same operation as the regular Security Code registra-
tion is to be conducted in the Security Code Writing screen.
When Enter key is pressed, writing begins.
Note: The Security Code to be input here must be the unique
code of the set liked with the serial number.
• When “Complete” is displayed, normal ending. When NG is
displayed, error.
Note: In case of NG, enter the Test Mode again and re-do
from the beginning.