Kenwood CS-3025, Инструкция по эксплуатации

Страница: 16 / 32

OPERATION
INITIAL STARTING PROCEDURE
Until you familiarize yourself w i t h the use of all controls, the following procedure may
be used to standarize the initial setting of controls a s a reference point and to obtain trace
on the C R T in preparation for w a v e f o r m observation.
W h e n using the probe(s), refer to probe's instructions and " P R O B E C O M P E N S A T I O N "
listed in A P P L I C A T I O N of this manual.
[1] NORMAL SWEEP DISPLAY OPERATION
1 . Push the P O W E R s w i t c h © — the power supply will be turned on and the pilot lamp
will light.
Set these modes a s f o l l o w s ;
V or Y M O D E @ : C H 1
T R I G M O D E ® : A U T O
2 . T h e trace will appear in the center of the C R T display and can be adjusted by the C H 1
^ P O S I T I O N © and ^ • P O S I T I O N © controls. Next, adjust the I N T E N S I T Y @ and,
if n e c e s s a r y , the F O C U S (fj) for ease of observation.
3 . Vertical Modes
Apply an input signal to the C H 1 INPUT ® j a c k and adjust the V O L T S / D I V © control
for a suitable size display of the w a v e f o r m . If the w a v e f o r m does not appear in the
display, adjust the V O L T S / D I V and
y
POSITION controls to bring the w a v e f o r m into
the center portion of the C R T display. Operation w i t h a signal applied to the C H 2 IN-
P U T
(J3)
j a c k and the V or Y M O D E set to C H 2 is similar to the above procedure.
In the A D D mode, the algebraic sum of C H 1 + C H 2 is displayed. If the C H 2 INV © s w i t c h
has been engaged, the algebraic difference of the t w o w a v e f o r m s , C H 1 — C H 2 is dis-
played. If both channels are set to the same V O L T S / D I V , the s u m or difference can
be read directly in V O L T S / D I V from the C R T . In the A L T mode, one s w e e p displayes
the channel 1 signal and the next s w e e p displays the channel 2 signal in an alternating
sequence.
16
Fig.
5