Kenwood CK 235 C SL, Инструкции по использованию и советы по установке

Страница: 41 / 44

41
1
2
3
5
4
N
L2
PE
L1
G
D
E
PE
N
L
ELECTRICAL FEEDER CABLE CONNECTION
WARNING: The power supply cable must be connected only by an authorised service
agent in order to avoid a hazard.
If the power supply cable is damaged, it must be replaced only by an authorised
service agent in order to avoid a hazard.
To connect the supply cable:
•
Unhook the terminal board cover by inserting a screwdriver into the two hooks “ A
” (fig. 10.1).
• Unscrew the screw “ D ” and open completely the cable clamp “ E
” (fig. 10.2).
• Connect the phase, neutral and earth wires to terminal board “ G ” according to the
diagram in fig. 10.3.
• Strain the feeder cable and block it with cable clamp “ E ” (by screwing screw “ D ”) .
• Close the terminal block cover (check the two hooks “ A ” are correctly hooked) .
NOTE: The earth conductor must be left about 3 cm longer than the others.
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws fixing
the cover plate behind the terminal block.
POWER SUPPLY
230 V 50 Hz 10700 W
FEEDER CABLE SPECIFICATIONS
Type “H05RR-F” or “H05VV-F”
3 x 4 mm
2
A
Fig. 10.1
Fig. 10.2
Fig. 10.3
230 V 50 Hz
230 V 50 Hz