Kentrox q2200, Руководство по установке

Страница: 14 / 22

14
Installing the router
For conceptual information on router features, see the User’s Guide . You can also
click Help in the router’s interface for information on the page you are viewing.
Step 1: Mount the router on a wall or in a rack
While the Kentrox router can be used on a desk top or table top, it may also be
mounted on a wall or in a rack for space efficiency and cable management. For ease
of handling, disconnect the power cable before wall- or rack-mounting the router.
Two 1-inch, #8 screws and anchors are included with the router. The anchors can be
used when attaching to drywall. Use the screws alone if attaching to a plywood
mounting panel. You will need longer screws—at least 1.25”—if attaching to a stud
through drywall.
Wall mounting instructions
a Drill two starter holes for the screws (or anchors) 7” apart.
3
Align the
screw holes vertically on the wall if you want to position the front panel
LEDs to the side, as shown in
Figure 2 .
b
If mounting on drywall, screw the anchors into the holes, then the screws
into the anchors. Leave 1/4” between the screw heads and the wall.
c Position the router over the screw heads, and slide the router downwards
and diagonally approximately 1/4” so that the screw heads are firmly posi-
tioned in the narrow part of the mounting slots.
d Power on the router, and proceed to Step 2 on page 16 .
Figure 2: Mounting the router on a wall
3
Use the drilling guides on the left side of this page to mark the screw hole locations.
3TUD
SCREWWITH
DRYWALLANCHOR
$RYWALL