Rev
F
: 01/2015
INSTALLATION INSTRUCTIONS
ALL ELECTRICAL WIRING MUST BE DONE BY A LICENSED ELECTRICIAN IN
ACCORDANCE WITH THE NATIONAL, STATE AND LOCAL ELECTRICAL CODES
.
(REFER TO NAMEPLATE ON TOOL FOR PROPER POWER CONFIGURATION).
1.
A BALANCER IS REQUIRED FOR OPERATION AND USE OF THIS TOOL. WEIGHT OF TOOL MUST FALL WITHIN
WEIGHT RANGE OF BALANCER.
2.
INSTALL BALANCER ABOVE WORK AREA. BALANCER MUST HAVE SUFFICIENT VERTICAL TRAVEL SO
OPERATOR CAN REACH ENTIRE WORK AREA WITH TOOL WITHOUT STRAIN.
3.
ADJUST BALANCER ACCORDING TO THE OPERATOR'S PREFERENCE AND COMFORT.
4.
TOOL REQUIRES GREASING AFTER EVERY 40 HOURS OF OPERATION. GREASE USING KENTMASTER
GREASE (PART NO. 7903030 FOR BEARINGS AND 7903090 FOR GEARS).
OPERATING INSTRUCTIONS
ONLY TRAINED PERSONNEL ARE TO OPERATE THIS TOOL.
1.
TO HELP ENSURE TOOL IS OPERATING PROPERLY, PERFORM FOLLOWING STEPS AT START OF EACH SHIFT:
•
MAKE SURE TOOL MOVES UP AND DOWN FREELY WHILE HANGING FROM BALANCER OVERHEAD.
•
WITH POWER TO TOOL TURNED ON, TEST TRIGGER FOR PROPER OPERATION.
•
DEPRESS EACH TRIGGER SEPARATELY. TOOL SHOULD NOT ACTIVATE. DEPRESS BOTH TRIGGERS. TOOL
SHOULD ACTIVATE.
•
IF TOOL HAS “ANTI-TIE DOWN” OPTION, BOTH TRIGGERS MUST BE DEPRESSED SIMULTANEOUSLY FOR
TOOL TO ACTIVATE.
2.
HOLD TOOL FIRMLY IN HAND WITH TRIGGER LEVERS IN POSITION TO BE ACTIVATED BY FINGERS.
3.
SQUEEZE TRIGGERS TO ACTIVATE TOOL, RELEASE TRIGGERS TO DEACTIVATE TOOL.
4.
POSITION TOOL AND PERFORM CUTTING OPERATION.
5.
DO NOT LAY TOOL DOWN WHEN TOOL IS NOT BEING USED
MAINTENANCE
ONLY TRAINED AND QUALIFIED PERSONNEL ARE TO PERFORM MAINTENANCE
AND SERVICE TO THIS TOOL.
1.
TOOL REQUIRES GREASING AFTER EVERY 40 HOURS OF OPERATION. GREASE USING KENTMASTER GREASE
(PART NO. 7903030 FOR BEARINGS AND 7903090 FOR GEARS)
BLADE REMOVAL AND CLEANING
ALWAYS DISCONNECT POWER SUPPLY FROM TOOL BEFORE INSTALLING OR
REMOVING BLADES FROM TOOL.
1.
REMOVE BLADE NUT (PART NO. 6003180, FIG. NO. 9 AND 10) USING WRENCH ( 4501610)
2.
REMOVE BLADE.
3.
SHARPEN BLADES WHEN NECESSARY.
5.
REASSEMBLE ALL PARTS IN REVERSE ORDER.
SERVICE
1.
KEEP GOOD RECORDS OF ALL SERVICE ACTIVITY AND INCLUDE TOOL IN YOUR PREVENTIVE MAINTENANCE
PROGRAM.
2.
USE ONLY GENUINE KENTMASTER REPLACEMENT PARTS TO ASSURE PROPER PERFORMANCE OF TOOL.
3.
CONTACT THE KENTMASTER SUPPLIER NEAREST YOU FOR PARTS
AND CUSTOMER SERVICE INFORMATION.
KENTMASTER MFG. CO., INC.
1801 SOUTH MOUNTAIN AVE., MONROVIA, CALIFORNIA 91016
UNITED STATES OF AMERICA
TELEPHONE
:
(818) 359-8888
FAX:
(818) 303-5151
Page 3 of 26
