REV E: 04/08
KENTMASTER MFG. CO., INC.
1801 SOUTH MOUNTAIN AVE., MONROVIA, CALIFORNIA 91016
UNITED STATES OF AMERICA
TELEPHONE
:
(818) 359-8888
FAX:
(818) 303-5151
Page 4 of 18
INSTALLATION INSTRUCTIONS
ALL ELECTRICAL WIRING MUST BE DONE BY A LICENSED ELECTRICIAN IN
ACCORDANCE WITH THE NATIONAL, STATE AND LOCAL ELECTRICAL CODES.
(REFER TO NAMEPLATE ON TOOL FOR PROPER POWER CONFIGURATION).
1.
A BALANCER IS REQUIRED FOR OPERATION AND USE OF THIS TOOL. WEIGHT OF TOOL MUST FALL WITHIN
WEIGHT RANGE OF BALANCER
2.
INSTALL BALANCER ABOVE WORK AREA. BALANCER MUST HAVE SUFFICIENT VERTICAL TRAVEL SO
OPERATOR CAN REACH ENTIRE WORK AREA WITH TOOL WITHOUT STRAIN
3.
ADJUST BALANCER ACCORDING TO THE OPERATOR'S PREFERENCE AND COMFORT.
WE STRONGLY SUGGEST THAT AN ADDITIONAL SAFETY CHAIN BE USED TO CHAIN
BALANCER TO OVERHEAD TROLLEY. THIS ADDITIONAL MEASURE OF SAFETY WILL
HELP REDUCE INJURIES.
MAINTENANCE
ONLY TRAINED AND QUALIFIED PERSONNEL ARE TO PERFORM MAINTENANCE
AND SERVICE TO THIS TOOL.
OIL LUBRICATION:
THE FAT OF THE CARCASS PROVIDES SUFFICIENT LUBRICATION FOR THE BLADE GUIDES AND
OIL LUBRICATION OF BLADE IS NOT NECESSARY WHEN MACHINE IS IN OPERATION.
SAW SHAFT REQUIRES CONTINUOUS LUBRICATION. VERIFY OILER CUP AT THE END OF EACH SHIFT AND ENSURE
THAT THE OILER CONTAINS LIGHT-WEIGHT, FOOD-GRADE OIL, ENOUGH TO COVER BOTTOM OF OILER CUP.
RECOMMENDED LUBRICANT CAN BE PURCHASED FROM “KENTMASTER MFG., CO., INC.”
!
WARNING
!
WARNING
!
WARNING
