REV E: 04/08
KENTMASTER MFG. CO., INC.
1801 SOUTH MOUNTAIN AVE., MONROVIA, CALIFORNIA 91016
UNITED STATES OF AMERICA
TELEPHONE
:
(818) 359-8888
FAX:
(818) 303-5151
Page 3 of 18
OPERATING INSTRUCTIONS
ONLY TRAINED PERSONNEL ARE TO OPERATE THIS TOOL.
1.
TO ENSURE TOOL IS OPERATING PROPERLY, PERFORM FOLLOWING STEPS AT START OF EACH
SHIFT:
•
MAKE SURE TOOL MOVES UP AND DOWN FREELY WHILE HANGING FROM BALANCER OVERHEAD.
•
WITH POWER TO TOOL TURNED ON, TEST TRIGGER FOR PROPER OPERATION.
2.
TO PERFORM WORK, HOLD TOOL FIRMLY AT BOTH HANDLES. SQUEEZE TRIGGERS TO ACTIVATE
TOOL.
3.
POSITION TOOL AND PERFORM CUTTING OPERATION.
BLADE REMOVAL AND CLEANING
.
ALWAYS DISCONNECT POWER SUPPLY FROM TOOL BEFORE INSTALLING OR
REMOVING BLADE FROM TOOL.
ALWAYS WEAR WIRE MESH GLOVES WHEN INSTALLING OR REMOVING BLADE FROM
TOOL.
1.
REMOVE NUT AND BOLT (ITEM NO. 2, 4, FIG. NO. 1).
2.
REMOVE BLADE (ITEM NO. 1, FIG. NO. 1).
3.
CLEAN ALL PARTS REMOVED WITH SOAP AND
WATER.
4.
SHARPEN OR REPLACE BLADES WHEN NECESSARY.
5.
REASSEMBLE IN REVERSE ORDER.
Figure 1 MODEL 500E – BLADE REPLACMENT
SERVICE
1.
KEEP GOOD RECORDS OF ALL SERVICE ACTIVITY AND INCLUDE TOOL IN PREVENTIVE
MAINTENANCE PROGRAM.
2.
USE ONLY GENUINE KENTMASTER REPLACEMENT PARTS TO ASSURE PROPER PERFORMANCE OF
TOOL.
3.
CONTACT THE KENTMASTER SUPPLIER NEAREST YOU FOR PARTS AND CUSTOMER SERVICE
INFORMATION.
!
WARNING
!
WARNING
!
WARNING
