Kentix DoorLock - Quick Guide
Prepare device
1.
Remove knob cover
2.
Pull out the lock from the battery compartment
Set up programming card set
1.
Hold the Servicekey card (
yellow
) in front of the knob,
wait for 5 seconds
2.
Hold Servicekey card in front of the knob again,
to start programming mode.
3.
Hold the battery change card (
green
) in front of the
knob,
wait for 5 seconds
4.
Hold the dismantling card (
blue
) in front of the knob,
wait for 5 seconds
5.
Hold the Servicekey card in front of the knob to exit
the programming mode
Functional check
1.
Hold the battery change card in front of the knob.
The holding pins for the knob cover are released and
can be pressed into the knob.
2.
Hold the dismantling card in front of the knob.
The knob moves into the dismantling position.
When the knob is attached to a profile cylinder, the
closing lug of the cylinder will turn along when the
knob is moved. The knob can be removed by turning
and pulling it slightly from the profile cylinder.
Systemcard
In case of loss of the Servicekey card the
code on the Systemcard is required to order
a new Servicekey card.
Servicekey card
The Servicekey card is required to
configure a DoorLock-device. Without this
card an initial setup or a later configuration
is not possible.
Battery change card
The Battery Change card releases the
cover of the knob for the exchange of the
two batteries.
The cover can then be removed with the
battery replacement tool.
Dismantling card
The Dismantling card releases the locking
of the knob at the door cylinder. It can then
be removed by gently turning and pulling
the knob. There is only one position in
which the knob can be removed.
Prepare device
1. Insert the supplied battery (type CR123) into the
door handle. Push the handle onto the door lever
and unscrew the allen screw.
2. For the cabinet lock open the battery
compartment with the battery changing tool at
the lower end. Now insert the battery into the
compartment (type ER 14250).
Set up programming card set
1. For door lever, wall reader and cabinet lock only
the Servicekey card is required.
The setup of battery change and dismantling
card is not required.
2. Hold the Servicekey card (
yellow
) in front of the
device’s reader unit,
wait for 5 seconds.
The initial setup is completed.
3. The cabinet lock must be activated via the
Wakeup button to set up the Servicekey card.
Functional check
1. A functional check with battery change and
dismantling card is not necessary.
2. For testing, user cards can be programmed with
the Servicekey card.
The programming of user cards is described
overleaf.
DoorLock-DC
DoorLock-LE,-WA,-RL
Programming card set
