Kentix DoorLock - Operating modes
Additional information for commissioning and operation can be found in the user manual on kentix.com.
Offline mode
Online mode
Application / Usage
Single or multiple doors in composite mode.
Configuration via network-capable AccessPoints (KXP-16 LAN).
For up to 1,500 doors and 2000 users (RFID cards).
Commissioning
1.
Teach in the programming card set or Servicekey card at the Kentix DoorLock device as described
overleaf.
2.
Prepare the AccessPoint for a connection to the network (see Kentix manual).
3.
The setup of the user cards in the AccessPoint can be done before the installation.
4.
Install the Kentix DoorLock device on the door or wall (see Kentix manual).
5.
Install the AccessPoint in the door area (distance 25 meters max.) and connect it to the
network (PoE-Switch).
Configuration / Programming
1.
The programming of the Kentix DoorLock components is done via the AccessPoint. If multiple
AccessPoints are used, the programming has to be done only at the AccessPoint which is marked as
„master“. This one then distributes the configuration to all connected AccessPoints („slaves“).
2.
New RFID cards for the users are added to the configuration by a „teach-in“ of the card(s) at any of
the DoorLock devices via the Master-AccessPoint.
Application / Usage
Single doors without composite mode.
Configuration via Servicekey card directly at the door.
For up to 10 users (RFID cards).
Commissioning
1.
Teach in the programming card set or Servicekey card at the Kentix DoorLock device as described
overleaf.
2.
Install the Kentix DoorLock device at the door or wall (see Kentix manual).
Configuration / Programming
1.
The programming of the Kentix DoorLock components is done with the Servicekey card directly at the
device. This procedure must be done separately for each of the DoorLock devices.
2.
New RFID cards for the users are added to the configuration by a „teach-in“ at the reader unit of the
DoorLock device.
This process is always started and stopped by holding the Servicekey card in front of the device.
The AccessPoint and also each of the Kentix DoorLock devices can be reset to factory defaults if necessary (e.g. in case of misconfiguration). For this the AccessPoint has a button reachable via a housing bore. For a reset
please follow the instructions in the Kentix user manual.
To reset a DoorLock device please proceed as follows:
1. Hold the Servicekey card (
yellow
) in front of the reader unit of the device and leave it in front of the reader until it quits the programming mode (15 seconds).
Wait for 5 seconds.
2. Hold the Servicekey card in front of the reader unit again and leave it in front of the reader unit. The device signalizes the deletion progress by a 15 second periodic buzzering.
Leave the Servicekey card in front of the device until the signalization stops.
Reset of the components
