3. Fix the SS ball valve to the ¼ inch port of the
3-way connector as shown in the figure.
5
6
7. Before connecting the power supply, it is important that you perform the following
functions:
i
Open the SS ball valve (Handle parallel to the ball valve) to start the flow of water into
the purifier.
ii Wait for 2-3 minutes to ensure that the filters are soaked in water.
White pipe is for raw water supply
5. Now connect one end of the white pipe to the SS
ball valve and other end to the lower pushfit elbow
fitting on the left hand side of the purifier labeled
as WATER IN.
Blue pipe is for reject water
6. Similarly, connect one end of the blue pipe to the
upper elbow fitting connector labeled as REJECT
WATER and leave the other end in the drain.
4. Connect the 3-way connector to the raw water supply as
shown in the figure. The threaded end of the 3-way connector
is fitted in line with the raw water supply. The other end
can be connected to a tap or can be plugged off if not
required.
Automatic Operation
Slot holes
Installation Instructions
n
n
n
n
The purifier automatically shuts off when the
water level drops below the maximum
storage tank is full
The purifier does not allow any water
The purifier does not start when inlet water
rejection in absence of electricity / when
2
tank is full
supply pressure falls below 0.3 kg/cm
The purifier automatically restarts when
TM
KENT PRIDE Mineral
RO is a convenient and easy-to-install wall mounting model.
Recommended Site Preparations:
Single Phase 100-250 V AC, 50-60 Hz supply not more than 3m away from the point of
installation
Raw water supply with ½ inch nipple not more than 3m away
Drain for reject water not more than 3m away
Installation space as per the dimensions of the purifier
Wall/ plane surface for mounting screws and holding the machine. Avoid installation on wooden
and metallic stands
For optimum inlet pressure, source water tank should be at least 10 ft above the
purifier installed
Install the purifier near a sink for easy availability of inlet and reject water lines
The system and installation must comply with state and local laws
and regulations
Installation Procedure :
1. Screw in the two 16x25 self taping screws (supplied with the
package) on a same horizontal level at a distance of 5.4
inches (138 mm) from each other in the wall.
2. Carefully hang the purifier on the wall with the help of wall
mounting slot holes present on the back side of the purifier
as shown in the figure below.
n
n
n
n
n
n
n
n