KENT Logfire II, Инструкция по установке и эксплуатации

Страница: 13 / 16

The air tube in your Kent wood fire is an important part of the appliance and helps ensure a
clean, efficient and controllable burn. However, air tubes are a consumable item and need
to be replaced from time to time as they are likely to degrade with continual exposure to the
extreme heat generated in the fire box.
The life of the air tube will depend on what is burnt in the fire, how hot the fire usually burns and
also the ash level. If the ash level is allowed to build up. This can push embers up and into the
holes stopping the air cooling effect. It also means hot embers are in closer proximity to the
tube, increasing the temperature exposure. Ensure ember levels do not build up to high, when
reloading the fire with fuel.
Replacing air tubes:
1. Remove bricks from both sides
2. Remove the pin from the end of the old tube
3. Slide tube to one side, this will release the opposite end
4. Pull released end up and towards the door and remove
5. Reverse process for installation of new tube
KENT AIR TUBES
Top front
KWF299-6905
Top rear
KWF299-6906
Air Tube Pin
KWF299-6900
REPLACEMENT PARTS
All Fires
Rata & Logfire II
Air Tube Spacer
KWF299-6257
All Fires
Replacement parts must be original Kent parts. Maintenance required should be carried out
by a suitably qualified service technician. Please consult your Kent retailer for their details. The
wood fire should not be modified in any way except in accordance with instructions supplied
by Kent.
13