Kent-Moore J-46079, Руководство пользователя

Страница: 6 / 14

6
Testing Receivers
The receiver test procedure is used to verify the receiver can receive and
translate the data from simulated sensor transmissions.
1. Enable the learn mode in the receiver. Refer to vehicle service manual
for more information.
2. Locate the J-46079 in a central location in the passenger compartment
of the vehicle.
3. Press and release the Simulate button .
4. Press and release the Start button .
5. Press and hold the Simulate button and the J-46079 will begin to
transmit a simulated sensor transmission. When the receiver receives
the simulated sensor transmission a horn chirp will sound, or the DIC
will display the next sensor to be learned.
6. Release the Simulate button . Press and release Yes button after a
horn chirp has sounded, or DIC message is displayed.
7. Proceed as in step 5 for the remaining 3 sensor locations until all 4
simulated sensor transmissions have been learned into the receiver’s
memory. The J-46079 will display the preset Id numbers and tire
pressures for each location.
8. With the scan tool, observe the TPM data list and verify the sensor
Ids and tire pressures match what is displayed on the J-46079 screen
and all 4 sensor modes are “Learn”.
NOTE: ON MODEL YEAR 2001-2004 SEVILLE AND CORVETTE, AND 2001-
2005 DEVILLE, THE SCAN TOOL DOES NOT DISPLAY THE SENSOR ID'S, OR
MODE AND CAN ONLY BE USED TO VERIFY TIRE PRESSURE/LOCATION
DATA.