Kenmore W11024189A, Руководство по установке

Страница: 24 / 84

24
3. Unscrew the metal cover and unscrew the blue regulator
cap. Keep the washer in place.
4.
Flip the blue regulator cap over and screw it back into the
metal cover.
5.
Screw the metal cover securely back into place. Do not
overtighten.
To Convert Surface Burners (Natural Gas to
Propane Gas)
1.
If the burner grates are installed, remove them.
2. Remove burner cap.
3. Remove the burner base.
4. Apply masking tape to the end of a 9/32" (7 mm) nut
driver to help hold the gas orifice spud in the nut driver
while changing it. Press nut driver down onto the gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set gas orifice spud aside.
5. Remove the orifice spuds shipped in the literature package
in the oven. Gas orifice spuds are stamped with a number,
marked with 1 or 2 color dots, and have a groove in the hex
area. Replace the Natural gas orifice spud with the correct
Propane gas orifice spud.
Refer to the following chart for correct Propane gas orifice
spud ratings and to spud holder card for proper placement.
Propane Gas Orifice Spud Chart for Surface Burners
Burner
Rating/Type
Color Size
(mm)
ID
number
Placement
15,000 BTU/
Stacked* Silver
Black/Orange 1.05
0.32 L105
L32 RF
14,200
BTU/Ultra/
Stacked* Silver 1.05 L105 LF/RF
8,000 BTU/
Semi Red/Orange 0.85 L85 RR
5,000 BTU/
Auxi Red/Blue 0.65 L65 LR
1,200 BTU/
Stacked/
Simmer* Black/Orange 0.32 L32 LF
(Simmer)
* Not in all kits/models
NOTE: Refer to the model/serial/rating plate located on
the oven frame behind the top left-hand side of the oven
door for proper sizing of spuds for each burner location.
6. Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT: Keep the Natural gas orifice spuds in case
of reinstallation with Natural gas.
7. Replace the burner base.
8. Replace burner cap.
9.
Repeat steps 1 through 7 for the remaining burners.
A B
A. Metal cover
B. Washer
C. Blue regulator cap
A
B
A. Natural gas position
B. Propane gas position
D
A
B
C
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
A
B
C
D
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
A
A. Propane groove