8 • 464222209
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes for gas to clear
away and repeat the lighting procedure. If the burner
does not ignite with the valve open, gas will continue
to flow out of the burner and could accidently ignite
Turn controls and gas source or tank OFF when not
in use.
WARNING
Sideburner Match Lighting
3.
Place lit match near burner.
4.
Turn sideburner knob to HI .
1.
Turn
OFF
all burner control valves.
4.
Push in and turn control knob to
HI
position for desired burner
Main Burner Match-Lighting
?
Do not lean over grill while lighting.
2.
Open lid during lighting. Turn on gas at LP cylinder.
3.
Place match into match holder (hanging from side of cart).
Light match, and place into lighting hole for desired burner to light.
to light. Be sure burner lights and stays lit.
5.
If ignition does NOT occur in 5 seconds, turn the burner
control knob off, wait 5 minutes for gas to clear away, and repeat
the match lighting procedure
6
. Ignite remaining burners by repeating steps 3 through 5 for
each burner.
1.
Turn
OFF
all burner control valves.
2.
Open the sideburner lid.
Turn on gas at LP cylinder.
Be sure burner lights and stays lit.
WARNING: Sideburner top cover must be open when
sideburner is in operation.
Emitter Plate Brackets
Side Burner Ignitor Lighting
?
Do not lean over grill while lighting.
1. Open lid during lighting.
2.Turn ON gas tank valve.
3
. Push and turn sideburner control knob to
HI
and immediately
press and hold
ELECTRONIC IGNITION
button.
4.
If ignition does NOT occur in 5 seconds, turn burner control
knob OFF, wait 5 minutes for gas to clear away, and repeat
5.
Repeat above steps to light each burner individually.
Turning Grill Off
•Turn all knobs to
OFF
position. Turn LP tank off by turning
OPD hand wheel clockwise to a full stop.
Ignitor Check
•Turn gas off at LP tank.
Push and turn burner control to .
"Clicking" should be heard and sparking seen each time
between collector box or burner and electrodes. See
"Troubleshooting"
if no click or spark occurs.
Valve Check
•Important: Make sure gas is off at LP tank before checking
valves
. Knobs lock in
OFF
position. To check valves, first
push in knobs and release, and knobs should spring back. If knobs
do not spring back, replace valve assembly before using grill.
Turn knobs to
LO
position then turn back to
OFF
position.
Valves should turn smoothly.
Before Your First Cookout
•Light burners, check to make sure they are lit, close the lid and
warm up grill on HIGH for 15 minutes. This curing of paint and
parts will produce an odor only on first lighting.
Burner Flame Check
•Light burner, rotate knobs from HIGH to LOW. You should see
a smaller flame in
LOW position than seen on HIGH. Always
check flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the
Troubleshooting Section
.
HI
LO
Hose Check
•
Before each use, check to see if hoses are cut, worn or kinked.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified in the Parts List.
Normal
Hose
Kinked
Hose
with risk of injury.
the lighting procedure.
The lighting holes are located at the front of the cooking grates
between the emitter plate mounting brackets.