Kenmore PG-40405S0L, Инструкция по использованию и уходу

Страница: 23 / 63

Burner Electrode
and Igniter Cover
□
Place the 5 burner electrode wires (thin black & thin orange), the ground wire (red capped)
and the igniter wire (large black
) through the pre-installed side panel clamp. See A. Note: If
wires are difficult to install, loosen the clamp screw, put the wires through the clamp and
retighten the screw.
□
Place the 4 thin black wires and 1 thin orange wire into the 5 narrow slots in the electronic
ignition module. Place the red capped ground wire into the slot outlined in orange. Place the
large black wire into the wide slot. See B
□
Attach the igniter cover with (2) M4x10 screws. See C (Note: If cover is hard to install, use a
screwdriver to press down on the right door heel hook to remove the door. Install the cover,
and reattach door.) See D
A B
C
23
M4X10 screw Qty: 2 pcs
D