3.
Place the hooked ends of the other power supply cable wires
under the outer terminal block screws (hooks facing right).
Squeeze hooked ends together. Tighten screws.
6.
Connect a separate copper ground wire from the external
ground conductor
screw to an adequate ground.
AWARNING
Venting Requirements
A.
External ground conductor
screw
B. Neutral groundmg
wire (green with yellow stripes)
C.
Neutral wire (white or center wire)
D. Grounding
path determined
by
8
qualifted electrician
c
o
•
•
A. External ground conductor
screw
B. Neutral grounding
wire (green with yellow stripes)
C.
Center silver-eo/ored
terminal block screw
D. Neutral
wire
(white or center wire)
E. ~.
(1.9
em) UL listed strain relief
B
A~
•
2.
Place the hooked end of the neutral wire (white or center wire)
of power supply cable under the center screw of terminal
block (hook facing right). Squeeze hooked end together.
Tighten screw.
4.
Tighten strain relief screw,
5.
Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down
screw.
Optional
3-wire
connection
Use lor direct
wire or power
supply cord where local codes
do not permit
connecting
cabinet-ground
conductor
to
neutral wire.
1.
Remove center terminal block screw.
2.
Remove neutral grounding wire (green with yellow stripes)
from external ground conductor
screw. Connect appliance
ground wire and the neutral wire (white
or
center wire) of
power supply cord/cable
under center. silver.colored
terminal
block screw. Tighten screw.
3.
Connect the other wires to outer terminal block screws.
Tighten screws.
•
•
4.
Tighten strain relief screws.
5.
Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down
screw,
Fire Hazard
Use a heavy metal vent.
Do not use a plastic
vent.
Do not use a metal loll vent.
Failure to lollow
these instructions
can result
in death
or lire.
WARNING:
To reduce the risk of fire. this dryer MUST BE
EXHAUSTED OUTDOORS.
4' (10.2 em) heavy metal exhaust
vent
and clamps must be used.
DURASAFE'M venting products
are recommended
and are
available from your local Sears store
or
Sears Service Center.
DURASAFE'M vent ~',oducts can be purchased from your dealer.
For further information,
please call1-800-4-MY-HOME''
(1-800-469-4663)
or visit our Internet site at:
www.sears.com.
•
The dryer exhaust must not be connected
into any gas
vent.
chimney, wall, ceiling, or a concealed
space of a building.
•
Do not use an exhaust hood with a magnetic latch.
•
Do not install flexible metal
vent
in enclosed walls. ceilings or
floors.
•
Use clamps to seal all joints. Exhaust vent must not be
connected
or secured with screws or other fastening devices
that extend into the interior of the duct. Do not use duct tape.
