•
Put power supply cable through the strain relief. The
strain relief should have a tight frt wrth the dryer cabinet
and be in a horizontal position. Tighten strain relief screw
against the power supply cable.
Slytp 2: Direct wire strain relief
•
l.hscrew
the removable
retaining
nut and any
screws
mn
a
'1','
(1.9 cm) UL listed strain relief (UL marking on
s:rain relief). Put the threaded
section
of the strain relief
t:>rough the hole below the temninal block opening.
Reaching
inside the terminal block opening,
screw the
rerTl:)vable retaining
nut onto the strain relief threads.
•
,
4-wire connection:
Power supply cord
Electrical
Connection
Oplions
If your home has:
And
you
will be
Go
10
Seclion
connecting to:
4-Wlre
receptacle
A UL listed.
4-wlre
connection:
(NEMA Type 14-30R)
120/240 volt
Power supply cord
(Q)
minimum,
30 amp. dryer
power supply
cord.
4-wire
direct
A fused
4-wire
connection:
~J..~
disconnect
or
Direct Wire
circuit breaker
box'
3-wire
receptacle
A UL I,sted.
3-wire
connection:
(NEMA type 10-30R)
120/240 volt
Power supply cord
~
minimum,
30 amp. dryer
power supply
cord.
3-Mre
direct
A fused
3-wire
connectIon:
mme~~
disconnect
or
Direct
Wire
circuit breaker
box .
-If local codes
do not permit the connection
of a frame-
grounding
conductor
to the neutral wire. go to "Optional
3-wire
connection"
section.
B
A
/
\
;:
A.
Removable
retaining
nut
B. Strain relilJf threads
4.
Now complete Installation following instnuctions for your type
of electrical
connection~
4-wire (recommended)
3.wire
[If
4-wire
is not available)
IMPORTANT:
A 4-wlre connection
IS required for mobile homes
and where
local codes
do not permit the use of
3-wire
connections.
'~~
,~~
WeD
E
G
A. 4-wire receptacle (NEMA rype f4-30R)
B 4.prong
pfug
C.
Ground
prong
D.
N9Utral
prong
E.
Spade
termina's
with uptumed
ends
F ~.
(7.
gem)
UL listed strain
relief
G.
Ring terminals
