Kenmore Dishwasher, Руководство по установке

Страница: 4 / 32

4
Figure 2
Figure 3
3-1/2"
(89mm)
1-5/16"
(33mm)
23-5/8" – 24-1/8"
(600mm – 613mm)
Enclosure Preparation
Figure 4
If the enclosure requires openings for the electrical
supply cable, hot water supply line, and dishwasher
drain hose, place them within the dimensions shown
by the shaded area of Figure 4 to avoid interference
with the dishwasher frame or other components.
Make the openings for the electrical supply cable and
hot water supply line 1” (25.4mm) diameter. Make the
opening for the dishwasher drain hose 1-1/4” (32mm)
diameter. If the openings are made through wood,
sand them smooth. If the openings are made through
metal, make them large enough to accomodate
grommets or other protective sheaths with inside
diameters of 1” (25.4mm) for the electrical supply
cable and the hot water supply line, and 1-1/4”
(32mm) for the dishwasher drain hose.
ENCLOSURE PREPARATION
NOTE: The dishwasher is designed to be enclosed on
the top and both sides by standard residential kitchen
cabinetry.
Select a location as close to the sink as possible for
easy access to water supply and drain lines.
For proper dishwasher operation and appearance,
ensure that the enclosure is square and has the
dimensions shown in Figure 2.
If the dishwasher is to be installed in a corner, make
sure that there is adequate clearance to open the
door, as shown in Figure 3, letter A.
WARNING: ELECTICAL SHOCK/
FIRE HAZARD - Heat from the hot
water supply line can cause electrical
cable’s insulation to break down, pre-
senting risk of electrical shock or fire.
Do not run the electrical supply cable
and the hot water supply line where
they can make contact with each other.