Kenmore BC3002, Инструкция по использованию и уходу

Страница: 21 / 48

- 21 -
End Cap
End Cap
Belt Path
Brush Unit
TO CLEAN BRUSHROLL:
NOTE: In order to keep cleaning e ffi ciency
high and to prevent damage to your vacu-
um cleaner, the brushroll must be cleaned
every time the belt is changed.
The brushroll must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use Clean Brushroll
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
LIGHT - every 2 months
(used 1 time/week)
IMPORTANT
Turn o ff and unplug vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up in the PowerMate ®
brushroll and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush unit area.
Carefully remove any string wound onto
the brushroll and end caps.
BRUSHROLL ASSEMBLY
2. Place brushroll
assembly back
into PowerMate ® .
TO REPLACE BELT
1. Install new belt over motor shaft, then
over belt path.
NOTE: See REPLACEMENT PARTS for part
number and purchase details (page 5).
3. Line up front of cover and base. Rest
cover on front edge of base as shown.
4. Rotate cover back. Press cover fi rmly until
side and rear latches snap into place.
NOTE: Make sure there is no gap between
the cover and base.
5. Turn PowerMate
®
upside down and replace
the four (4) screws that secure the cover
to the base.
Cover
Base
Brushroll