Kenmore 721.7603 series, Руководство по установке

Страница: 8 / 28

INSTALLING THE RANGE
8
INSTALLING THE RANGE
INSTALLING THE ANTI-TIP
DEVICE
INSTALL THE BRACKET USING THE
BRACKET INSTALLATION SHEET
Anti-tip
bracket
Wall plate
Screw must
enter wood or
concrete
The anti-tip bracket is packaged with an installation
template.
The instructions include necessary information to complete
the installation.
Read and follow range installation instruction sheet.
• Range must be secured with an approved anti-tip
device.
• The range could be tipped by standing, sitting or
leaning on an open door if the range or anti-tip
device is not properly installed.
• After installing the anti-tip device, verify that it is
in place by carefully attempting to tilt the range
forward.
• This range has been designed to meet all recognized
industry tip standards for all normal conditions.
• The installation of the anti-tip device must meet all
local codes for securing the appliance.
• The use of this device does not preclude tipping of
the range when not properly installed.
WARNING
PROVIDING ADEqUATE GAS
SUPPLY
The range is designed to operate at a pressure of 5” of
water column on natural gas or 10” of water column on
LP.
Make sure you are supplying your range with the type of
gas for which it is configured.
This range is convertible for use on natural or LP gas. When
using this range on LP gas, conversion must be made by
a qualified LP installer before attempting to operate the
range.
For proper operation, the pressure of natural gas supplied
to the regulator must be between 5” and 13” of water
column.
For LP gas, the pressure supplied to the regulator must be
between 10” and 13” of water column. When checking for
correct operation of the regulator, the inlet pressure must be
at least 1” more than the operating (manifold) pressure as
given above.
The pressure regulator located at the inlet of the range must
remain in the supply line regardless of which type of gas is
being used.
A flexible metal appliance connector used to connect the
range to the gas supply line should have an I.D. of 5/8”
and a max of 5ft. In Canada, flexible connectors must be
single wall metal connectors less than 6 feet in length.