16
Heated Dry
The Heated Dry option in combination with rinse aid will
give you excellent drying results. The energy to use Heated
Dry costs pennies per cycle. Heated Dry is on when the
light is lit on the Heated Dry button. Be sure to load plastic
items in the upper rack to avoid damage.
You may turn off the Heated Dry option by pressing
HEATED DRY so that the light goes off. However, you will
have items in your dish load that will not be dry at the end
of the cycle.
NOTE:
The Heated Dry option is used in all cycles except
Quick Rinse.
Lock On
Use the Lock On to avoid unintended use of the
dishwasher. You can also use the lock feature to avoid
unintended cycle or option changes during a cycle.
When LOCK ON is lit, all buttons are disabled.
NOTE:
The dishwasher door can be opened while the
controls are locked. However, the lock must be turned off
and the Start/Resume button pressed to resume the cycle.
To turn on the Lock
Press and hold HEATED DRY for 4 seconds. LOCK ON
glows.
If you press any pad while your dishwasher is locked, the
light flashes 3 times.
NOTE:
If the Heated Dry option is selected, the light will
temporarily turn off until Lock On glows.
To turn off the Lock
Press and hold HEATED DRY for 4 seconds. The light turns
off.
Delay Hours
Select this option to run your dishwasher at a later time or
during off-peak hours. You can add items to the load
anytime during the delay. After adding items, firmly close
the door until it latches and press START/RESUME, or the
delay will not continue.
To delay the start
1.
Press the delay button to choose the number of hours
delayed.
2.
Select a wash cycle and options.
3.
Press START/RESUME.
The dishwasher starts the cycle in the selected number of
hours.
NOTES:
■
To cancel the delay and cycle, press CANCEL/DRAIN.
■
To cancel the delay and start the cycle, press START/
RESUME.
Cycle Status Indicators
Follow the progress of your dishwasher with the Cycle
Status indicators.
NOTE:
The features on your dishwasher may vary from
those shown here.
Clean
Clean glows when a cycle is finished. The light turns off
when you press any button or close the door.
Sanitized
If you select the Sani Rinse option, Sanitized glows when
the Sani Rinse cycle is finished. If your dishwasher did not
properly sanitize your dishes, the light flashes at the end of
the cycle. This can happen if the cycle is interrupted or the
incoming water temperature is too low. The light turns off
when you press any button or close the door.
Active Vent
The active vent reduces the sounds from your dishwasher.
The vent closes, after the cycle starts, to lock in sound.
The active vent opens when wash action ends and vapor
is vented into room. Between cycles, the vent stays open
for airflow, reducing the buildup of odors.
NOTE:
There is a slight noise when the cover closes or
opens. This is normal.
IMPORTANT:
The vapor is hot. Do not touch the vent
during drying.
Overfill Protection Float
The overfill protection float (in the front right corner of the
dishwasher tub) keeps the dishwasher from overfilling. It
must be in place for the dishwasher to operate.
Check under the float for objects that may keep the
protector from moving up or down.
