8 • 464810208
CAUTION
If burner does not light, turn knobs to OFF, wait 5
minutes, and try again. Always close valve during the 5
minute waiting period. If the burner does not ignite with
the valve open, gas will continue to flow out of the burner
and could accidentally ignite with risk of injury.
Main burner Ignitor Lighting
s
Do not lean over grill while lighting.
1. Open lid during lighting.
2.
3.
Turn ON valve from source or tank.
Push and turn Ignition Burner control knob to HI and
immediately press and hold Electronic Ignition button.
4.
If ignition does NOT occur in 5 seconds, turn Left Burner
control knob
OFF
, wait 5 minutes for gas to clear and repeat
the lighting procedure.
5.
To Light Other Burners turn control knob to HI.
If ignitor does not work, follow match lighting instructions.
After Lighting: Turn knobs to HI position for 15 minutes to pre-
heat grill. Then turn knob to desired setting for cooking.
Match-Lighting
s
Do not lean over grill while lighting.
1. Open lid during lighting.
2.
Place match into match holder (hanging from side of cart).
3.
Push in and turn left knob to HI position. Be sure burner
lights and stays lit.
4.
Light right burner by pushing knob in and turning to HI
position.
Sideburner Ignitor Lighting
If ignitor does not work, follow match lighting instructions.
After Lighting: Turn knobs to HI position for warm-up.
Sideburner Match Lighting
1.
Open top cover.
2.
Hold lit match to any port on the burner. Push in and turn
sideburner knob to HIGH. Be sure burner lights and
stays lit.
s
Do not lean over grill while lighting.
1. Open lid or cover for Side Burner during lighting.
2. Turn
ON
valve from source or tank.
3. Push and turn Side Burner control knob to HI and
immediately press and hold Electronic Ignition button.
4. If ignition does
NOT
occur in 5 seconds, turn Side Burner
control knob
OFF
, wait 5 minutes for gas to clear, and
repeat the lighting instructions.
Turn on gas at LP tank.
Before Your First Cookout
• Light burners, check to make sure they are lit, close the lid and
warm up grill on HIGH for 15 minutes. This curing of paint and
parts will produce an odor only on first lighting.
Burner Flame Check
• Light burner, rotate knobs from HIGH to LOW. You should see
a smaller flame in
LOW position than seen on HIGH. Always
check flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the
Troubleshooting Section
.
HI
LO
Hose Check
•
Before each use, check to see if hoses are cut, worn or kinked.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified in the Parts List.
Normal
Hose
Kinked
Hose
