Kenmore 401.85052010, Руководство по обслуживанию

Страница: 10 / 50

10
4. Installation
The Microwave Oven is supported by a special bracket
assembly (mounting system) supplied with the oven .
The bracket assembly must be mounted to the wall
with toggle bolts through the wall, and a lag screw
into a wall stud . After the bracket assembly is installed,
the unit can be slid over the two rails of the bracket
assembly . Two bolts are run down through the cabinet
bottom and into the oven case to pull the oven up
against the cabinet bottom .
NOTE : For easier removal and personal safety it is
recommended that two people remove this product .
Mounting Plate
PRECAUTION
The mounting surface must be capable of supporting the cabinet load, in addition to the 64 pound
product, plus additional loads of up to 50 pounds or a total weight of 114 pounds . This product cannot
be installed to cabinet arrangements such as an island or peninsula . It must be mounted to both a top
cabinet and wall .
VENT BLOWER
The vent or exhaust blower is located at the top of the
oven . It is shipped for recirculating exhaust but can be
changed to rear exhaust or vertical (See installation
instrustions on how to change and/or blower section on
how to remove) .
COOKTOP LIGHTS
One 20-watt screw base halogen bulb is located on the
bottom . The bulb is user replaceable by removing one
screw and lowering access cover .
OVEN LIGHT
A 40-watt screw base incandescent bulb is located in the
top of the oven cavity at the front .
It is user replaceable by removing the top grill (4 screws .
On the front of outer case .) . The bulb is then accessible by
removing a metal cover .
REUSABLE GREASE FILTERS
The metal filter trap grease released by foods on the
cooktop. They also prevent flames from foods on the
cooktop from damaging the inside of the microwave .
For this reason, the filter must ALWAYS be in place when
the hood the vent fan is used. The grease filter should be
cleaned once a month, or as needed .