14
1.
Remove the dust
bin.
2.
Slide the lever in
the direction of the
arrow to remove
the embedded dust.
3.
Push the release button, open the dust
bin, and then open the filter.
4.
Take out the cleaning brush (included) to
clean the dust filter and pre-filter.
5.
Push the dust filter cover release latch to
pull out dust filter cover.
6.
Wash all
parts of the
dust bin.
7.
Allow filter to dry 24 hours before
putting back into vacuum cleaner.
NOTE:
When the cleaning of the filter no
longer restores vacuum cleaner suction to
full power, replace the filter.
DO NOT operate without filter installed.
DO NOT wash in the dishwasher.
DO NOT install damp.
8.
Install the dust
filter cover along
inside of locating
strip, and make
sure you hear a
“click.”
9.
Close the dust
bin and reattach
it as shown.
CLEANING DUST BIN
WARNING
Turn off and unplug vacuum cleaner
before performing maintenance to the
vacuum cleaner.
CAUTION
• Do not attempt to dry with a hair
dryer or by placing in clothes dryer.
Hot air may cause the filters to warp.
• It is not necessary to wash after each
use.
Release
Button
Filter
Dust
Filter
Brush
Dust Filter
Cover Release
Latch
Dust Filter
Cover
Locating
Mark
Inside of
locating
strip
Dust Filte
Cover
Lever
