4
17
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING
Read
Use
Disconnect
Do not
To
Do
not
Do not
Do not
Do not
Do not
Do not
Do not
Do not
Keep
all instructions in this manual before
assembling or using your vacuum cleaner.
your vacuum cleaner only as
described in this manual. Use only with
Sears recommended attachments.
electrical supply before
servicing or cleaning out brush area.
Failure to do so could result in electrical
shock or brush suddenly starting.
leave vacuum cleaner when
plugged in. Unplug from outlet when not in
use and before servicing.
reduce the risk of electrical shock –
use outdoors or on wet surfaces.
allow to be used as a toy. Close
attention is necessary when used by or
near children.
use with damaged cord or plug. If
vacuum cleaner is not working as it should,
has been dropped, damaged, left outdoors,
or dropped into water, return it to a Sears
Service Center.
pull or carry by cord, use cord as a
handle, close door on cord, or pull cord
around sharp edges or corners. Do not run
vacuum cleaner over cord. Keep cord away
from heated surfaces.
unplug by pulling on cord. To
unplug, grasp the plug, not the cord.
handle plug or vacuum cleaner with
wet hands.
put any objects into openings.
use with any opening blocked; keep
free of dust, lint, hair and anything that may
reduce airflow.
hair, loose clothing, fingers, and all
parts of body away from openings and
moving parts.
Turn off
all controls before unplugging.
Use extra care
Do not
Do not
Do not
Always
Do not
Do not
The hose
Do not
Do not
Always
Hold plug
Do not
You
when cleaning on stairs. Do
not put on chairs, tables, etc. Keep on
floor.
use vacuum cleaner to pick up
flammable or combustible liquids (gasoline,
cleaning fluids, perfumes, etc.), or use in
areas where they may be present. The
fumes from these substances can create a
fire hazard or explosion.
pick up anything that is burning or
smoking, such as cigarettes, matches, or
hot ashes.
use vacuum cleaner without dust
bag and/or filters in place.
change the dust bag after
vacuuming carpet cleaners or freshener,
powders and fine dust. These products clog
the bag, reduce airflow and can cause the
bag to burst. Failure to change bag could
cause permanent damage to the vacuum
cleaner.
use the vacuum cleaner to pick up
sharp hard objects, small toys, pins, paper
clips, etc. They may damage the vacuum
cleaner or dust bag.
operate vacuum cleaner without the
exhaust filter or exhaust filter door in place
(If applicable).
contains electrical wires.
use when damaged, cut, or punctured.
Replace if cut or worn.
pick up
sharp objects.
turn off and unplug the vacuum
cleaner before connecting or disconnecting
either hose, Handi-Mate Jr.® (if applicable),
or nozzle.
when rewinding onto cord reel.
allow plug to whip when rewinding.
are responsible for making sure that
your vacuum cleaner is not used by anyone
unable to operate it properly.
Proper assembly and safe use of your vacuum cleaner are your responsibilities.
Your vacuum cleaner is intended for
. Read this Owner’s Manual
carefully for important use and safety information. This guide contains safety
statements under warning and caution symbols.
Household use
Your safety is important to us. To reduce the risk of fire, electrical shock,
injury to persons or damage when using your vacuum cleaner, follow basic
safety precautions including the following:
4. Aligner le
devant du
couvercle et la
base. Poser le
couvercle sur le
bord avant de la
base comme
illustré.
5. Tourner le couvercle
arrière. Appuyer
fermement sur le
couvercle jusqu’á ce
que les languettes
arrière se trouvent en
place avec un déclic.
6. Retourner Power-Mate
®
sur le dos et remettre les
deux (2) vis du couvercle.
Couvercle
Base
1. Enlever le couvercle du Power-Mate
®
comme
démontré dans la section POUR CHANGER LA
COURROIE ET NETTOYER L’AGITATEUR.
2. Pousser sur l'am-
poule en la tournant
vers la gauche, puis
tirer pour l'enlever.
POUR CHANGER L’AMPOULE
Enfoncer
et tourner
3. Pousser sur l'am-
poule en la tournant
vers la droite pour la
remplacer. L’ampoule
ne doit pas dépasser
130 volts (15 watts).
4. Remettre le couvercle du Power-Mate
®
comme
démontré dans la section POUR CHANGER LA
COURROIE ET NETTOYER L’AGITATEUR.
REMARQUE: Voir PIÈCES ET
CARACTÉRISTIQUES pour le numéro de l’ampoule.
Enfoncer
et tourner
POUR REMETTRE LA
COURROIE EN PLACE
1. Poser la
nouvelle
courroie
pardessus
l’entraînement
du moteur,
puis pardessus
l’entraînement
de brosse.
REMARQUE:
Voir PIÈCES ET CARACTÉRISTIQUES pour le
numéro de la courroie.
2. Placer l’ensem-
ble de l’agitateur
dans le Power-
Mate
®
.
3. Remettre le
couvercle de l’agi-
tateur en alignant
les languettes
avant et les fentes
et tournant vers le
bas jusqu’à ce
que les loquets se
trouvent en place
avec un déclic.
Entraînement
du moteur
Entraînement
de brosse
Agitateur
Capuchon
d’extrémité
Languettes
Couvercle de
l’agitateur
FRAN
Ç
AIS
