Kenmore 110.65212610, Инструкция по использованию и уходу

Страница: 12 / 40

12
If you experience
Possible Causes
Solution
Cycle time too short Automatic cycle ending early.
The load may not be contacting the sensor strips. Level the dryer.
Use Timed Dry for very small loads. Change the dry level
setting on Auto Dry cycles.
Increasing or decreasing the dry level setting will change the
amount of drying time in a cycle.
Lint on load Lint screen clogged. Lint screen should be cleaned before each load.
Stains on load or drum
Dryer fabric softener not properly
used.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your items.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Loads are wrinkled The load was not removed from dryer
at the end of the cycle.
Select Wrinkle Guard™ option to tumble the load without heat
to avoid wrinkling.
Dryer tightly packed.
Dry smaller loads that can tumble freely, reducing formation
of wrinkles.
Odors
You have recently been painting,
staining, or varnishing in the area
where your dryer is located.
If so, ventilate the area. When the odors or fumes are gone from
the area, rewash and dry the clothing.
The electric dryer is being used
for the fi rst time.
The new electric heating element may have an odor. The odor
will be gone after the fi rst cycle.
Load is too hot Laundry items were removed
from the dryer before the end
of the cycle.
Allow cool down to fi nish before removing laundry from dryer.
All cycles are cooled slowly to reduce wrinkling and make it
easier to handle. Items removed before cool down may feel
very warm.
A high temperature cycle was used
or the Dry Temp was set on High.
Select a lower temperature, and use an automatic drying cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
TROUBLESHOOTING