6
7
OPERATION
ATTACHING 360
0
SPLASH GUARD
(See Fig. 4)
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Push the splash guard up to fit onto the
seating ring on the underside of the Tilt Head.
OPERATION
SPEED CONTROL DIAL
(See Fig. 6)
The Speed Control Dial is located on the
right side of the Mixer, and is scaled in
digits from 0 to 10
(0 equals OFF).
To start the Mixer, turn the Speed Control
Dial clockwise from 0.
When using the Splash Guard, you may
immediately turn the dial to the optimum
speed of your recipe.
If not using the Splash Guard, start the mixer on the slowest possible speed and
gradually raise to optimum speed to avoid splashing ingredients out of the bowl.
OPERATION SAFETY FEATURES
- If the mixer is plugged into an outlet when the speed dial is turned to a speed setting,
the mixer will not start and the work light will flash. Unplug the cord and turn the speed
dial to 0 before plugging it back in.
- If you attempt to lift the tilt head while the mixer is running, the mixer will shut off and
the work light will go out. When you lower the head back into place, the work light will
flash. Turn speed dial to 0 and then to a speed setting to restart mixer.
- If the mixer motor becomes overheated, the mixer will shut off and the work light
will
flash. Turn the speed dial to 0 and allow mixer motor to cool down before restarting.
ATTACHING MIXING ACCESSORIES
(See Fig. 5)
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Align slot at the top of accessory with pin
on Tilt Head shaft. Push accessory up onto
shaft and turn counterclockwise until pin moves
all the way into the slot.
REMOVING 360
0
SPLASH GUARD
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Pull off the splash guard.
REMOVING MIXING ACCESSORIES
1. Turn speed dial to 0.
2. Unplug mixer from electrical outlet.
3. Press down release lever to tilt head back.
4. Turn Accessory clockwise on shaft until pin on shaft lines up with slot on accessory.
Pull accessory off shaft.
Seating
Ring
Fig. 4
WARNING:
Never turn on Mixer with accessories attached unless the
Bowl is in place.
CAUTION:
When you are finished mixing, turn the speed dial to 0
and unplug Mixer from the electrical outlet to prevent accidental starting.
CAUTION:
Do not scrape the bowl while the Mixer is operating.
The bowl and beater are designed to provide thorough mixing without
frequent scraping. Scraping the bowl once or twice during mixing is usually
sufficient. Turn the Mixer off (Speed Dial to 0) before scraping.
Fig. 5
Speed digit
Fig. 6
NOTE:
As an optional attachment method,
lay the splash guard on top of the bowl and
lower the Tilt Head onto it.
