Kencove Solar Dolly, Инструкция по сборке

Страница: 3 / 6

Assembly Instructions
Page 2
Fig. 1
Step 1: Attach left and right stabilizer legs to
battery box. Be sure to face the bolts outward
as shown in Fig. 1. Note: This is the only attach-
ment where bolts should face outward.
Step 2: Attach left and right
uprights to the battery box and
the stabilizer legs.
Step 3: Attach adjustable angle
brackets using the holes on side
of the uprights. The holes used
to mount these brackets are
dependent upon geographic
location. See page 3 for
more details.
Fig. 2
Step 4: Attach the panel brackets. Use the first
and third bolt holes to attach the brackets to
the uprights and adjustable angle brackets (Fig.
2). The middle hole is used for the controller
mounting bracket.
Step 5: Attach controller
mounting bracket using the
middle holes on the panel
brackets. The ends should
point toward front of dolly
as shown below.
Step 6: Attach energizer
mounting brackets
via the holes on the
backside of the uprights.
Note: Spacing of the
energizer brackets
depends on size of the energizer.
Step 7: Insert the axle into the bottom holes
on the uprights. Attach each wheel by sliding a
washer onto the axle, then sliding the wheel
onto the axle with the hub facing inward as
shown. On the outer side, insert another washer
and place cotter pin in the hole. Bend the cotter
pin to fasten wheel on the axle.
Step 8: Place the handlebar through the top holes
in the panel mounting brackets and slide on the
rubber grips
.
Hub