Kencove Solar Dolly, Инструкция по сборке

Страница: 6 / 6

Step 3: Attach the energizer
Figures 2a and 2b:
Attach energizer to mounting
brackets with supplied white zip ties.
Figures 4a, 4b and 4c:
Connect the controller to the battery
with the battery cable. Use a small straight screwdriver to loosen
the middle pair of screws on the front of the controller so the
bare ends of the battery cable can be inserted into the bottom of
the controller (Be sure the battery is already charged). Be sure
the positive/negative wires correspond with the correct slots
on the controller. After securing the wires, attach the jumper
ends of the cable to the battery terminals. The “Bat” light and
the red light in the corner of the controller will show when the
connection is made.
Figures 5a and 5b: Connect the solar panel cable to the controller.
Install the bare wires in the corresponding slots on the left side
of the controller. Once the cable is installed, the “Sun” light will
show.
Figures 6a and 6b: Connect the wires from the energizer to the
controller by inserting them in the slots on the right side of the
controller. After connecting the wires, turn the energizer on to
ensure correct connections. Your Solar Dolly™ electric fencing
system is now ready to be connected to the fence.
Fig. 2
a. b.
Fig. 6
Step 4: Connect the components
Fig. 3
b.
a.
Fig. 4
a.
b.
c.
Fig. 5
b.
a.
a.
b.
Figures 3a and 3b: If using a
Stafix Dual
Purpose Energizer, remove of alligator clips (mark
positive and negative wires prior to removal). Strip
insulation from wire ends.
Remove