KEN DW 412
Section/page:4.1
Subject to alterations
17/9/2013
Installation instructions
Receipt/transport/unpacking
Check immediately whether the machine has been damaged in transit.
If so, complain to the carrier immediately.
The easiest way of transporting the machine is by means of a pallet forklift.
Disposal of packaging
Packaging is separated into: Wood, cardboard and plastic, and is disposed
of in accordance with local/national rules on waste disposal.
Installation/connection
Table connection:
Lead the entry edge on the table into the machine; the table finishes with a
15 mm entry edge to be placed on the machine edge. Install the tables with
a slope towards the machine to allow the water to run into the machine.
If the machine is to be placed in a corner, do not place any underneath
shelves closer than 500 mm to the machine front plate to allow service.
Water connection:
Connect the machine to cold or hot water, min. 5°C and max. 65°C.
It is important to keep the flow pressure at 15 l/min. at min. 200 kPa and to
never let the static pressure exceed 800 kPa.
Measure the pressure at the machine entry hose.
The coupling line to the machine must be fitted with a blocking valve and a
non-return valve, possible combined as a settable non-return valve.
If the machine is equipped with a rinse aid system or a dosage system, this
must be protected against backflow in line with the VA approval of the
equipment concerned.
The machine must be connected to the water installation with the
accompanying hose or another VA-approved hose.
Poss. decalcifying filter/softening system:
See special instructions for installation, but be aware that the filter may be
connected to max. 65°C hot water as regards KEN filter types TB and MB.
Drain:
The machine can be connected to a floor drain, a sink drain or directly to the
downpipe. In the two last-mentioned cases, a ø50 mm watertrap is required.
The drain pipe may be horizontal, but may not be taken more than 5 m away
from the machine. The water must be able to run off the machine of its own
accord. If required, fit a drain pump to the machine. In such case, remember
that the drain pipe must be lifted to the level shown at illustration.
Total machine weight:
Excl. packaging
Incl. packaging
KEN DW 412
102 kg
116 kg
Drain pipe
Содержание 59.480
Страница 2: ......
Страница 9: ...KEN DW 410 Section page 3 1 Subject to alterations 17 9 2013 Technical description Dimensional sketch ...
Страница 33: ......
Страница 40: ...KEN DW 412 Section page 17 1 Subject to alterations 17 9 2013 Diagrams ...