Ken A Vision Video Flex 7200HD, Инструкция по эксплуатации

Страница: 7 / 12

7
NOTE: Before installing the microscope eyepiece adapter, measure the size of
the outside diameter of the microscope eyepiece to be sure the adapter will fit
over the end of the eyepiece. Remove the rubber eyecup if present.
1. Place the microscope eyepiece adapter over one of the microscope's
eyepieces. If there is a rubber eyecup on the microscope eyepiece, it
should be removed first. If there are two eyepieces on your microscope,
light entering the open eyepiece will not cause any problems with imag-
ing.
2. Attach the Video Flex
®
to the eyepiece adapter by gently sliding the
Video Flex
®
camera head onto the eyepiece adapter, aligning the micro-
scope adapter with the inside opening of the Video Flex
®
camera (inside
the knurled focusing ring).
Note: Use only genuine Video Flex
®
parts and accessories. All Ken-A-Vision
parts provided are made specifically for the Video Flex
®
and failure due to use
of non-Ken-A-Vision parts will void the warranty!
8. Lighting:
Your Video Flex
®
operates using ambient, room light. If using camera in a
severely darkened room, supplement the light entering the camera by using a
penlight, flashlight or small lamp near the camera, so that there is more local
input light for the camera to work with.
Never point your Video Flex
®
at direct sunlight. Subjecting the Camera "eye"
to direct sunlight will discolor the filter over the CMOS chip causing aberrant
colors and or permanent focusing problems. It may even destroy the camera's
ability to capture an image.