CHARGING YOUR KEN-A-VISION CORDLESS MICROSCOPE
1. Before using your new cordless microscope be sure to charge it first.
2. The “On/Off” switch on the microscope should be in the “Off” position.
Plug in the round pin adapter from the battery charger to the back of
your microscope.
3.Connect the opposite end to a 110v (220v international) electrical
outlet.
4. With one over-night charge (8 hours) you can use your microscope for up
to 40 hours of continuous operation.
Note: Itis not necessary to completely recharge the microscope in order to
operate. Nor is it necessary to fully discharge the microscope prior to
recharging.
When battery power is low, the power supply/charger may be plugged in
and the microscope operated normally.
TECHNICAL SPECIFICATIONS FOR MODEL NO. T-1701C & T-1702C
· Power Source Life: 500 recharging Cycles (
approximately 4-5 years depending on usage
)
· Light Source: Ken-A-Vision Cool Light Technology Equivalent to a
20 Watt Bulb
· Power Source: Built-in rechargeable NiMH (Nickel Metal Hydride)
· “Light Board” Life 100,000 Hours
· Cool Operating Temperature Less Than 25°C (75°F)
· 10 year limited warranty on microscope.
EQUIPMENT RATING:
DESCRIPTION OF INPUT OUTPUT CONNECTION
Should you need a replacement power supply, contact Ken-A-Vision or your
dealer. When using internationally, be sure to use the correct AC voltage either
110V, 220V, or 240V output voltage (catalog # VFPS230R-2 (230v) or
VFPS1209300R (110v). Output voltage is 9 volt DC 300mA and a 2.5 mmV
barreled styled center position plug. connection of
The power supply/charger are made exclusively for the Ken-A-Vision Cordless
Microscopes. Failure to use Ken-A-Vision parts will void the warranty of your
microscope.
Note: This equipment has been tested and found to comply with the limits for
UL Standard 61010A-1.
ENVIRONMENTAL CONDITIONS
This equipment is designed to be safe under the following conditions:
· indoor use;
· altitude up to 2 000 m
· temperature 5° to 40°C;
· maximum relative humidity 80% for temperatures up to 31°C
decreasing linearly to 50% relative humidity at 40°C;
· main supply voltage fluctuations not to /-- 10% of the
nominal voltage;
· transient overvoltages according to installation categories;
· Pollution Degree 2 in accordance with IEC661
Normally non-conductive pollution occurs. Occasionally, however,
a temporary conductivity caused by condensation must be expected.
EQUIPMENT MAINTENANCE
All cordless microscopes should be recharged PRIOR to storage.
The battery type is NiMH (Nickel Metal Hydride)
Should you need a replacement power supply/charger, or battery, contact your
nearest Ken-A-Vision dealer or www.ken-a-vision.com.
INSTRUCTIONS FOR REPLACEMENT OF BATTERIES
Remove the bottom plate of the microscope. Next remove the old NiMH
batteries and properly discard.
To replace the NiMH batteries simply replace NiMH batteries with new NiMH
batteries.
WARRANTY
Ten year warranty against defective parts and workmanship (excludes
lamp and batteries).
