X8 MIG WELDER
2.3 Installation
2.3.3.6 Attaching interconnection cable to strain relief
To ease the installation of the interconnection cable and to prevent any unnecessary strain on the cable
connectors, attach both ends of the interconnection cable bundle to a strain relief.
Proceed as follows:
1.
Attach the strain relief holder to the transportation handle at the rear of the power source. Fasten the
strain relief holder with a bolt from below.
2.
Take the power source end of the interconnection cable and insert the strain relief pin to the strain relief
holder.
Note:
If the wire feeder is detached from the power source, insert the strain relief pin to the holder
from below.
Note:
If the wire feeder is on the power source, insert the strain relief pin to the holder from above.
OPERATING MANUAL | EN
49
©
KEMPPI | 2018-09-28
