X5 FastMig
Operating manual - EN
2.11 Installing and changing wire (X5 WF 300)
This section describes how to install the wire and spool on X5 Wire Feeder 300.
Install the welding gun to the wire feeder before installing the wire spool.
When changing the wire spool, remove the remaining filler wire from the welding gun and wire feed mechanism
before removing the wire spool.
Always ensure that the feed rolls are suitable for the filler wire (diameter and material) in question. Refer also to
"Installing and replacing feed rolls" on page 59.
To remove the wire spool:
1.
Open the wire feeder top cover.
2.
Push the wire spool locking cover to the rear.
3.
Remove the wire spool from the wire feeder.
© Kemppi
53
1920960 / 2144
