X5 FastMig
Operating manual - EN
WF end step
ON/OFF
Default = OFF
Wire feed end step. This feature prevents
the filler wire from sticking to the work
piece when the welding ends. This is
accomplished by pulling the wire back
briefly.
Dynamics
Min/Max = -10.0 ... +10.0, step 0.2
Default = 0
Controls the short circuit behavior of the
arc. The lower the value the softer the arc,
the higher the value the rougher the arc.
Post current
-30 ... +30, step 1
Default = 0
Post current setting affects the wire
length at the weld end. This also enables
the optimum wire length for the start of
the next weld.
Wire feed speed min
Min/Max = 0.5 ... 25 m/min, step 0.1
Default = 0.5 m/min
Minimum and maximum limits for the
wire feed speed adjustment.
Wire feed speed max
Min/Max = 0.5 ... 25 m/min, step 0.1
Default = 25 m/min
Voltage min
Min/Max = According to welding equip-
ment specifications, step 0.1
Minimum and maximum limits for the
welding voltage adjustment.
Voltage max
Min/Max = According to welding equip-
ment specifications, step 0.1
Remote mode
OFF/Remote/Gun
Default = OFF
If remote controller is not connected, this
selection is not available.
Water cooler
OFF/Auto/ON
Default = OFF
Wire retract
OFF/ON
This is an automatic wire retract feature.
Once the arc is extinguished, the wire is
retracted for additional safety. The user
can change the wire retract delay and
length settings.
- Retract delay
2...10 s, step 1
Default = 5 s
- Retract length
1...10 cm, step 1
Default = 2 cm
Weld data averages
Without slopes / Entire weld
Default = Without slopes
This feature allows the user to change
how the weld data averages are
calculated: with or without the slope
phases in the beginning and in the end
of the weld.
This setting affects the calculation of the
averages for the following: welding
voltage (terminal and arc voltage), weld-
ing current, welding power and wire feed
speed.
Voltage display mode
Terminal voltage / Arc voltage
Default = Arc voltage
This defines which is shown on the con-
trol panel display, terminal or arc voltage
Safe wire inch
ON/OFF
Default = OFF
When ON, and the arc doesn't ignite, the
filler wire is fed 5 cm. When OFF, 5 m of
filler wire is fed.
Cable calibration
Calibrate/Cancel
The date and time and the calibration
information of the previous calibration is
also shown.
Refer to "Calibrating welding cable" on
page 73 for cable calibration.
© Kemppi
77
1920960 / 2144
