Kemppi X5 FastMig Manual 400, Руководство по эксплуатации

Страница: 92 / 214

X5 FastMig
Operating manual - EN
4.4 Troubleshooting
The problems listed and the possible causes are not definitive, but suggest some typical situations that may turn up dur-
ing normal use of the welding system.
Welding system:
Problem Recommended actions
The welding system does not power up
Check that the mains cable is plugged in properly.
Check that the mains switch of the power source is at the ON pos-
ition.
Check that the mains power distribution is on.
Check the mains fuse and/or the circuit breaker.
Check that the interconnection cable between the power source
and the wire feeder is intact and properly attached.
Check that the earth return cable is connected.
The welding system stops working
Gas-cooled gun may have overheated. Wait for it to cool down.
Check that none of the cables is loose.
The wire feeder may have overheated. Wait for it to cool down and
see that the welding current cable is properly attached.
The power source may have overheated. Wait for it to cool down
and see that the cooling fans work properly and the air flow is
unobstructed.
Wire feeder:
Problem Recommended actions
The filler wire on the spool unravels
Check that the spool locking cover is closed.
The wire feeder does not feed the filler wire
Check that the filler wire has not run out.
Check that the filler wire is properly routed through the feed rolls
to the wire liner.
Check that the pressure handle is properly closed.
Check that the feed roll pressure is adjusted correctly for the filler
wire.
Check that the welding cable is properly connected to the wire
feeder.
Blow compressed air through the wire liner to check that it is not
blocked.
Weld quality:
Problem Recommended actions
© Kemppi 93 1920960 / 2039