Kemper 620 00, Инструкция по установке и эксплуатации

Страница: 29 / 72

© www.kemper-olpe.de – 11.2020 – K410062000000-00 – 29 / 72
Scope of application | General information
1
The KEMPER Leak Protection System for protection against water damage caused by leaks
in the potable water system as well as for automatic protection of potable water systems
when leaving buildings (with or also without water sensor) see 1.2.1. The timer programs
additionally facilitate automatic protection when leaving the building and during long
absences (see 3.2.8).
The KEMPER Leak Safety System in the basic version comprises a:
• leak controller
• an Isolating valve and
• a water sensor
The cut-off valve is installed in the flow path directly before the DW system/subsection that
is to be monitored. The water sensor is mounted near the floor in the room to be monitored.
If there is a water film > 0.5 mm on both water sensor contacts, that state is detected in
the controller using a direct-current resistance measurement and the KHS VAV with servo
drive is closed immediately before the DW installation section to be protected. Up to two
individually monitored detector circuits can be set up through one leak controller. 25 water
sensors can be safely connected per detector circuit. The leak is acoustically and visually
indicated on the controller. The alarm can be forwarded to a BMS. Comply with the wiring
instructions in 3.2 to preclude electronic interference.
Functional description of "Protect"
1.1