Owner’s manual
EN
5
Power socket x3 with remote control
Read this instruction manual carefully before first use, and keep it for futurereference.
1. Features:
• Each socket can be manually operated or via the handy remote control
(individual on and off buttons on the remote control).
• Easy to use and operate – use one remote to control a single socket receiver or
program more than one remote to each socket receiver. Any remote and socket
of this type can be matched with each other.
2. Installation:
• Install one 12 V/23 A battery in the remote’s battery compartment, making sure
the polarity of the battery is correct.
• Plug socket into a power socket and plug a device into the socket.
3. Operation:
Note
: Remote-controlled sockets are preprogrammed for immediate use.
To reprogram the remote control transmitter and socket receiver, please follow
the instructions below.
1. Plug the socket receiver into a power socket.
2. Press and hold the learning button on the right side of the socket until the LED
indicator begins to flash.
3.
Release the learning button and then press the desired “on” or “off” button
on the remote.
4.
Programming is successful when the LED indicator stops flashing.
4. Reset (cancel all pairings between sockets and remotes):
1. Remove the socket from the wall/power socket.
2. Press and hold the Learning button.
3. Plug the outlet back into the wall/power socket while continuing to hold the
Learning button.
4. Hold the learning button for approximately 5 seconds until the LED indicator
begins to flash.
5.
When the LED flashes rapidly several times and stops, the socket receiver has
been reset.
5. Change the battery:
Regularly change the battery in the remote control for best performance. If the
remote buttons are not responding or the LED indicator on the remote control
becomes dim, the battery should be replaced.