Kelvinator Refrigeration Cleaning your refrigerator
11
Cleaning your refrigerator
Changing the light bulb – Top and Bottom Mount fridge
1. Switch off the power at the power point and remove
the refrigerator’s power cord from the power point.
2. Carefully unclip the light cover. You do this by pushing
the light cover tabs at the front towards the back of
the cabinet, then lowering the cover down.
3. Unscrew the light bulb and replace it with a bulb that
is the same as the original, as specified on the rating
plate behind the cover. If, when you remove the light
bulb the small rubber “O” ring comes out with the bulb,
fit the “O” ring over the new bulb and screw bulb into
the socket (see diagram below).
warning
Never insert your finger into the light bulb socket
to check for the presence of the “O” ring.
tips and information
Ensure the ‘O’ ring is in place before replacing
the bulb.
4. Replace the light cover by hooking the light cover lugs
into the rear of the housing and pressing the front of
the cover until it clips in.
5. Wait 5 minutes to ensure pressures in the refrigeration
system are equalized. Then reconnect and turn the
refrigerator on at the power point.
warning
Before cleaning: Turn appliance off at the power point,
then remove power cord from socket. This will make
sure there is no chance of getting an electric shock.
Doors and exterior
You should only clean the doors with lukewarm soapy
water and a soft cloth, rinsing with clean water and then
wipe the surface with clean water and a soft clean cloth
to remove soap residue.
caution
Do not use stainless steel cleaners, abrasive pads or
other cleaners as they are likely to scratch the surface.
Damage to this product after delivery is not covered
by your warranty.
Interior
You should clean the appliance interior regularly. It will be
easiest to clean when the food supply is low. Wash the interior
with a soft cloth and use an unscented mild soap with luke-
warm water. Thoroughly dry all surfaces and removable parts.
Avoid getting water on appliance controls. If you have taken
out any removable parts, replace them and switch the power
on before re-stocking the appliance with food. Naturally,
you should keep the interior of your appliance hygienic by
promptly and thoroughly wiping up any food spills.
Door seals
Take care to keep door seals clean. Sticky food and drink
can cause seals to stick to the cabinet and tear when you
open the door. Wash seal with a mild detergent and warm
water. Rinse thoroughly and dry.
warning
Never use hot water, solvents, commercial kitchen
cleaners, aerosol cleaners, metal polishes, caustic or
abrasive cleaners, or scourers to clean this appliance,
as they will damage it. Many commercially available
cleaning products and detergents contain solvents
that will damage your refrigerator. When cleaning,
use only a soft cloth with an unscented mild soap
and lukewarm water.
Light bulb
“O” ring
Light socket
Содержание refrigerator
Страница 1: ...Refrigeration Use Care ...
