4 Installation
Kelvinator Air Conditioning
Safety precautions
1 A dedicated power supply circuit should be used for
products not supplied with a service cord and plug in
accordance with local electrical safety regulations.
3 The unit must be reliably earthed and connected to
the special earth device by a qualified electrician.
4 The circuit breaker must have the functions of magnetic
tripping and heat tripping to prevent short circuit
and overload.
5 The appliance must be installed in accordance with
national wiring regulations.
6 Including a circuit breaker with suitable capacity, please
note the following table.
Model
Circuit Breaker (Amps)
KSV26CRC
10
KSV26HRC
10
KSV35CRC
10
KSV35HRC
10
KSV53HRC
15
KSV62HRC
15
KSV70CRC
20
KSV70HRC
20
KSV80HRC
20
Note:
• Make sure the live wire, neutral wire and earth wire in
the power socket are properly connected.
• Inadequate or incorrect electrical connections may cause
electric shock or fire.
Earthing requirements
1 Air conditioner is type I electric appliance. Please ensure
the unit is reliably earthed.
2 The yellow-green wire in air conditioner is the earthing
wire which cannot be used for other purposes. Improper
earthing may cause electric shock.
3 The earth resistance should adhere to the national
wiring regulation.
4 The user's power must have reliable earthing terminal.
Do not connect the earthing wire with the following:
1. Water pipe
2. Gas pipe
3. Contamination pipe
Installation
Installation site instructions
A proper installation site is vital for correct and efficient
operation of the unit. Avoid the following sites where:
• strong heat sources, vapours, flammable gas or volatile
liquids are emitted.
• high-frequency electro-magnetic waves are generated
by radio equipment, welders or medical equipment.
• salt-laden air prevails (such as close to coastal areas).
• the air is contaminated with industrial vapours and oils.
• the air contains sulphurous gas such as in hot spring
zones.
• corrosion or poor air quality exists.
Installation site of indoor unit
1 The air inlet and outlet should be away from the
obstructions. Ensure the air can be blown through the
whole room.
2 Select a site where the condensing water can be
easily drained out, and where it is easily connected for
the outdoor unit.
3 Select a place where it is out of reach of children.
4 Select the place where the wall is strong enough to
withstand the full weight and vibration of the unit.
5 Be sure to leave enough space to allow access for routine
maintenance. The installation site should be 2m or more
above the floor.
6 Select a place about 1m or more away from a TV set or
any other electric appliance.
7 Select a place where the filter can be easily taken out.
8 Make sure that the indoor unit is installed in accordance
with installation dimension instructions (refer to page 5).
9 Do not use the unit in the laundry or by a swimming
pool etc.
Installation site of outdoor unit
1 Select a site where noise and outflow air emitted by unit
will not annoy neighbors.
2 Select a site where there is sufficient ventilation.
3 Select a site where there is no obstruction blocking the
inlet and outlet.
4 The site should be able to withstand the full weight
and vibration of the unit.
5 Select a dry place, but do not expose the unit to direct
sunlight or strong wind.
6 Make sure that the outdoor unit is installed in accordance
with the installation instructions, and is convenient for
maintenance and repair.
7 Ensure that the height difference between indoor and
outdoor units complies with the table on page 8.
8 Select a place where it is out of reach of children.