Kelvinator 2SF-13, Руководство по обслуживанию и установке

Страница: 7 / 40

FIG. 2
Cleaning Instructions
DIRECTIONS FOR PROPER CARE &
CLEANING
1. Wipe up spilled foods promptly.
2. Use lukewarm detergent solution for cleaning the
cabinet interior, exterior, and lids. Follow with a clean,
damp cloth and then wipe dry.
3. Protect the exterior enamel finish and plastic lid frame
with automotive type cleaner and wax.
4. Protect all stainless steel surfaces with a commercial
silicone emulsion type cleaner. This cleaner is excell-
ent for all stainless steel surfaces. It leaves a protect-
ing film that prevents fingermarking and the adher-
ence of food particles.
5. CAUTION:
a. Never use naptha or solvent type cleaner on plas-
tic parts or lid frames.
b. Never use harsh abrasive polishes on plastic parts
or plastic lid frames.
c. Do not blow steam or dash excessively hot water
against plastic materials when cleaning the tank or
defrosting, as damage to plastic parts may occur.
6. When the cabinet is taken out of service for more than
a short period:
a. Remove lids. (DO NOT replace them on the cabi-
net until the cabinet is again refrigerated.)
b. Defrost cabinet and remove any spilled ice cream
from the chamber guards.
c. Wash and dry chamber guards and cabinet interi-
or. (See Item 2 above.)
INSTRUCTIONS FOR SEALING
CABINET TO FLOOR
The National Sanitation Foundation recommends these
cabinets be sealed to the floor to prevent water, dirt and
vermin, etc. from getting under the cabinet. The instruc-
tions below meet their requirements.
1. Position and level the cabinet.
2. Draw outline of the base on the floor.
3. Raise and block the front side of the cabinet as illus-
trated in FIG. 1.
4. Apply a bead of mastic (See approved list below) to
the floor one half inch inside the outline drawn. (See
FIG. 2.) Bead must be heavy enough to compress at
all points when the cabinet is set down.
5. Raise and block the rear of the cabinet as illustrated
in FIG. 1.
6. Apply mastic on the floor as outlined in step 4 on the
other three sides.
7. Examine to see that cabinet is sealed to floor around
entire perimeter.
NOTE. Asphalt floors are very susceptible to chemical
attack. A layer of tape on the floor prior to applying the
mastic will protect the floor.
APPROVED MASTICS
3M #EC800 ............................................................Caulk
3M #EC2185 ..........................................................Caulk
3M #EC1055 ..........................................................Bead
3M #EC1202 ..........................................................Bead
Armstrong Cork ........................................Rubber Caulk
Products Research Co. #5000 ..................Rubber Caulk
G.E. Silicone Sealer
CLEANING INSTRUCTIONS 5
FIG. 1