Kelly KLS-H, Руководство пользователя

Страница: 34 / 35

31
2,3 ¤¤ ¤¤¤ Over temperature
The controller temperature has exceeded 100
℃
. The
controller will be stopped but will restart when
temperature falls below 80
℃
.
2,4 ¤¤ ¤¤¤¤
Throttle error at
power-up
Throttle signal is higher than the preset
‘dead zone’ at
Power On. Fault clears when throttle is released.
3,1 ¤¤¤ ¤ Reserved
3,2 ¤¤¤ ¤¤ Internal reset May be caused by some transient fault condition like
a temporary over-current, momentarily high or low
battery voltage. This can happen during normal
operation.
3,3 ¤¤¤ ¤¤¤
Hall throttle is open
or short-circuit
When the throttle is repaired, a restart will clear the
fault.
3,4 ¤¤¤ ¤¤¤¤ Angle sensor error 1.Speed sensor type error
，
customers may set the
correct sensor type through user program or App.
Please download how to use Identification function
instruction from our website.
2.Incorrect wiring.
3.Speed sensor is damaged or defective.Or feedback
signal is erratic.
4,1 ¤¤¤¤ ¤ Reserved
4, 2 ¤¤¤¤ ¤¤ Reserved
4, 3 ¤¤¤¤ ¤¤¤ Motor
over-temperature
Motor temperature has exceeded the configured
maximum. The controller will shut down until the
motor temperature cools down.
4, 4 ¤¤¤¤ ¤¤¤¤ Hall Galvanometer
sensor error 1.Hall galvanometer device is damaged inside the
controller.
This error code is only valid for KLS-8080I controller.
Customers may read error codes in PC software or Android Tablet