17
ADJUSTMENT OF CUTTING HEIGHT
The cutting height can be adjusted at three (3) places: the tow bar, the support roller and the
wheels.
To raise or lower the cutting unit, adjust the following: raise or lower the wheels, raise or lower
the tow bar and roller or the tow bar and wheels.
Adjust the height as follows:
STEP 1
Wheels = Raise and lower the wheels by turning the levers. Check that both wheels are
at the same height.
Adjustment of wheel height.
When in operating mode, the
wheels must be adjusted. Turn the
height adjustment levers to raise
and lower the wheels.
STEP 2
Combination of tow bar and support roller = Lengthen the tow bar (screw/turn the
turnbuckle) to raise the tow bar or shorten it to lower it.
Raise the roller by loosening bolt 'B', loosen and remove bolt 'A'. (Repeat this on both sides of
the roller.) Then select a different hole and replace bolt 'A'. Tighten bolts 'A' and 'B' (illustration)
A
B
Содержание 35-VKMATV120H
Страница 24: ...24 Table of Contents ...
Страница 29: ...29 Table of Contents NOTES ...
Страница 30: ...30 Table of Contents NOTES ...
