Kellfri 35-VKMATV120H, Руководство по эксплуатации

Страница: 16 / 32

16
Table of Contents
STARTING THE ENGINE
1. Read and understand the engine's operating manual before using the machine.
2. Observe all safety regulations: Keep hands and feet away from blades and other moving
parts.
3. Ensure that bystanders are at a safe distance from the machine.
4. Ensure that there is space between the blades and the ground/grass.
5. Select an area free of loose objects that can be ejected.
6. Turn the choke to the on position and set at idling.
7. Place one foot on top of the machine so that you have a firm grip and a good balance.
Pull the starter cord and let it return slowly back to the engine.
8. Allow a few minutes for the engine to warm up while idling. Set the throttle at
the factory setting for operation in order for the engine to have a normal working
speed of max. 3600 rpm.
Warning!
Altering the accelerator setting to increase rpm above the recommendations given
can invalidate the warranty. Cutting performance will decline, fuel consumption will
increase and major vibrations may arise, leading to danger for persons and damage
to equipment.
DRIVING AND SPEED
The amount of grass to be cut determines the forward speed; low speed usually produces the
best results. Ensure that you follow the sequence below.
Normal speed:
1 km/h for heavy
work, 10 km/h for light work. Start with the lowest possible speed; ensure that the flail mower
is working effectively with the engine at maximum rpm without straining. (If this is not possible
because of very tough cutting conditions, raise the cutting level and cut the same area twice,
the second time with a lower cutting level. Allow at least 24 hours between first and second
cutting to allow the grass to dry out.)
Increase the forward speed until the engine starts to labour, then slow down immediately and
maintain a speed where the engine runs easily. It is important to always listen to the engine
to be sure that the engine and flail mower are working effectively - slow down or stop if the
engine starts to labour.
Warning!
When changing from normal to heavier cutting, it is usual for the engine to start labouring
with a drop in rpm. SLOW DOWN IMMEDIATELY so that the engine returns to normal rpm
and speed. Follow the instructions above in “Normal speed”. Expected speed is much lower
when the machine is working hard.
FAILURE TO DO SO WILL RESULT IN THE POWER-TRANSMISSION SLIPPING AND VERY SERIOUS
DAMAGE TO THE CLUTCH AND DRIVE BELTS.