Kellfri 27-SF20, Инструкция по эксплуатации

Страница: 14 / 32

14
CUTTING BLADE
Among the most critical elements of the Stump Machine is the cutting blade. It is also the
most subject to damage and wear. In the course of cutting stumps it not only makes contact
with the wood, but also encounters numerous assortments of abrasives and objects in the
stump’s environment, such as dirt, stones, and occasionally a large rock or buried scrap. The
loss of and wear of cutting teeth can significantly impair the efficiency and performance of the
Stump Machine. Therefore, it is important to make frequent observations of the condition of
all of the cutting teeth and replace or sharpen any damaged or worn blade sections. Read all
of the following instructions before beginning to change cutting blade sections.
CHANGING CUTTING BLADE SECTIONS.
NOTICE!
Read all the following instructions before beginning to change cutting blade sec-
tions.
1. Clean all dirt from the cutting blade and mounting flanges.
2. Remove all bolts holding cutting blade, (Be careful not to let a section drop when they
become loose).
3. Check each section for cracks. Replace blade section if it is cracked.
4. When replacing cutting blade sections, make sure blade section is placed in alignment
with blade rotation.
5. Refer to page of this Manual for proper blade attachment.
Insert blade section between the blade mounting flanges.
Slide bolt through one side of flange, through one side of
flange, through blade section, and through flange on oth-
er side. Attach lock washer and nut, tighten securely. (Make
sure tow bolts are tightened for each blade section).