Kellfri 27-SF20, Инструкция по эксплуатации

Страница: 12 / 32

12
Operation
Stage 1
1. Place stump machine into position with cutting blade near the front-top edge of stump.
2. Set brake to lock position.
3. Set throttle to (START ) DISENGAGE position.
4. Start engine.
5. Allow engine to warm up at idle for two minutes.
6. Move throttle up to the ENGAGE position (this will engage the cutting blade rotation).
7. Swing the cutting blade to one side, then lower it approximately 1/2” to 1” into the front-
top corner of the stump. Swing the cutting blade back and forth, lowering the cutting
blade approximately 1/2 “to 1” before each sweep, until you have removed the front por-
tion of the stump to ground level. (fig.6-7)
To swing or steer the machine, press down on the handle and turn the rear wheels.
6
7
8. Raise cutting blade until center of cutting blade is just above top of stump.
9. With the cutting blade off to one side, advance the machine horizontally by releasing and
resetting the brake. Advance the machine forward to engage the cutting blade into the
stump so that when swept across the stump it will remove 1/2” to 1” of stump with each
sweep.
10. Sweep the cutting blade across the stump, cutting away 1/2” to 1” of stump.
11. Advance cutting blade 1/2” to 1”, and sweep across stump in opposite direction.
12. Continue sweeping cutting blade left and right across stump, advancing it before each
sweep, cutting 1/2” to 1” depth of stump with each sweep.
13. Continue cutting until top level of stump is all removed, making sure not to cut stump
deeper than ground level during this first stage.
14. Turn throttle to the (START) DISENGAGE position, wait ten seconds for blade to stop rotat-
ing then release brake and retract machine from stump.
15. Pull machine away from stump, and rake chips away from stump
Stage 2
16. 16. Place stump machine into position with cutting blade near the front-top edge of the
stump.
17. Set brake to lock position.
18. Move throttle up to the ENGAGE position.
19. Complete cutting stump by repeating step 12 again and again until entire stump is cut
to desired depth.
20. Stop the machine.
Caution Never leave the machine with the engine running and the blades rotating!
Keep people and animals at a safe distance when the blades are in motion!